ASTM D3419-12(2019)
- Standard Practice for In-Line Screw-Injection Molding Test Specimens From Thermosetting Compounds
- standard by ASTM International, 05/01/2019
- Category: ASTM
$42.00
$21.00
1.1 This practice covers the general principles to be followed when injection molding test specimens of thermosetting materials. It is to be used to obtain uniformity in methods of describing the various steps of the injection molding process and in the reporting of those conditions. The exact molding conditions will vary from material to material, and if not incorporated in the material specification, shall be agreed upon between the purchaser and the supplier or determined by previous experience with the particular type of material being used and its plasticity.
Note 1: The utility of this practice has been demonstrated for the molding of thermosetting molding compounds exhibiting lower-viscosity non-Newtonian flow.
PDF
All of our standards document are available in PDF (Portable Document Format), an electronic, downloadable format.You will be able to download the file in your account downloads.
Multi-User Access
After purchasing, you have the ability to assign each license to a specific user.
Printable
At any time, you are permitted to make printed copies for your and your members' reference use.
ASTM F3148-17a
Standard Specification for High Strength Structural Bolt Assemblies, Steel and Alloy Steel, Heat Tre..
$27.00 $54.00
ASTM B286-07(2017)
Standard Specification for Copper Conductors for Use in Hookup Wire for Electronic Equipment..
$24.00 $48.00
ASTM F3200-17
Standard Terminology for Driverless Automatic Guided Industrial Vehicles..
$29.00 $58.00
ASTM E2458-17
Standard Practices for Bulk Sample Collection and Swab Sample Collection of Visible Powders Suspecte..
$27.00 $54.00