ASTM E2092-18
- Standard Test Method for Distortion Temperature in Three-Point Bending by Thermomechanical Analysis
- standard by ASTM International, 06/01/2018
- Category: ASTM
$58.00
$29.00
1.1 This test method describes the determination of the temperature at which the specific modulus of a test specimen is realized by deflection in three-point bending. This temperature is identified as the distortion temperature. The distortion temperature is that temperature at which a test specimen of defined geometry deforms to a level of strain under applied stress of 0.455 MPa (66 psi) (Method A) and 1.82 MPa (264 psi) (Method B) equivalent to those used in Test Method D648. The test is applicable over the range of temperature from ambient to 300 °C.
Note 1: This test method is intended to provide results similar to those of Test Method D648 but are performed on a thermomechanical analyzer using a smaller test specimen. Equivalence of results to those obtained by Test Method D648 has been demonstrated on a limited number of materials. The results of this test method shall be considered to be independent and unrelated to those of Test Method D648 unless the user demonstrates equivalence.
PDF
All of our standards document are available in PDF (Portable Document Format), an electronic, downloadable format.You will be able to download the file in your account downloads.
Multi-User Access
After purchasing, you have the ability to assign each license to a specific user.
Printable
At any time, you are permitted to make printed copies for your and your members' reference use.
ASTM C955-15e1
Standard Specification for Load-Bearing (Transverse and Axial) Steel Studs, Runners (Tracks), and Br..
$25.00 $50.00
ASTM D7693/D7693M-15
Standard Guide for Application of Heat Weldable Modified Bituminous Waterproofing Membranes Systems ..
$21.00 $42.00
