AWS A5.22/A5.22M:2012
- Specification For Stainless Steel Flux Cored and Metal Cored Welding Electrodes and Rods
- standard by American Welding Society, 01/17/2012
- Category: AWS
$72.00
$36.00
welding, flux cored stainless steel rods for root pass welding with the gas tungsten arc process, and metal cored stainlesssteel electrodes for gas metal arc welding, gas tungsten arc welding, plasma arc welding, submerged arc welding, andany other process to which they may be applied.
The chromium content of undiluted weld metal from these electrodes and rods is not less than 10.5% nominal and theiron content exceeds that of any other element. For purposes of classification, the iron content shall be derived as the balanceelement when all other elements are considered to be set at their specified minimum values.
Safety and health issues are beyond the scope of this standard and, therefore, are not fully addressed herein. Some safetyand health information can be found in Annex Clauses A5 and A10. Safety and health information is available fromother sources, including, but not limited to, ANSI Z49.1, Safety in Welding, Cutting, and Allied Processes, and applicablestate and federal regulations.
This specification uses both U.S. Customary Units and the International System of Units (SI). The measurements are notexact equivalents; therefore, each system must be used independently of the other without combining in any way whenreferring to material properties. The specification with the designation A5.22 uses U.S. Customary Units. The specificationA5.22M uses SI Units. The latter are shown within brackets ([ ]) or in appropriate columns in tables. Standarddimensions based on either system may be used for sizing of filler metals or packaging or both under A5.22 or A5.22Mspecifications.
The chromium content of undiluted weld metal from these electrodes and rods is not less than 10.5% nominal and theiron content exceeds that of any other element. For purposes of classification, the iron content shall be derived as the balanceelement when all other elements are considered to be set at their specified minimum values.
Safety and health issues are beyond the scope of this standard and, therefore, are not fully addressed herein. Some safetyand health information can be found in Annex Clauses A5 and A10. Safety and health information is available fromother sources, including, but not limited to, ANSI Z49.1, Safety in Welding, Cutting, and Allied Processes, and applicablestate and federal regulations.
This specification uses both U.S. Customary Units and the International System of Units (SI). The measurements are notexact equivalents; therefore, each system must be used independently of the other without combining in any way whenreferring to material properties. The specification with the designation A5.22 uses U.S. Customary Units. The specificationA5.22M uses SI Units. The latter are shown within brackets ([ ]) or in appropriate columns in tables. Standarddimensions based on either system may be used for sizing of filler metals or packaging or both under A5.22 or A5.22Mspecifications.
PDF
All of our standards document are available in PDF (Portable Document Format), an electronic, downloadable format.You will be able to download the file in your account downloads.
Multi-User Access
After purchasing, you have the ability to assign each license to a specific user.
Printable
At any time, you are permitted to make printed copies for your and your members' reference use.
