• SAE AMS3660D

SAE AMS3660D

  • Polytetrafluoroethylene (PTFE) Moldings, General Purpose Grade, As Sintered
  • standard by SAE International, 06/16/2010
  • Category: SAE

$81.00 $41.00

This specification covers virgin, unfilled, polytetrafluoroethylene (PTFE) in the form of molded rods, tubes, and shapes. This specification does not apply to product over 12 inches (305 mm) in dimension parallel to the direction of applied molding pressure, rods under 0.750 inch (19.05 mm) in diameter, and tubes having wall thickness under 0.500 inch (12.70 mm).

These moldings have been used typically for parts such as, bushings and insulators, requiring chemical inertness and good mechanical and electrical properties up to 500 \mDC (260 \mDF), but usage is not limited to such applications. For applications such as bearins, seals, and back-up rings that do not require dielectric properties it is recommended to use AMS 3678/1 Grade A.
PDF

All of our standards document are available in PDF (Portable Document Format), an electronic, downloadable format.You will be able to download the file in your account downloads.

Multi-User Access

After purchasing, you have the ability to assign each license to a specific user.

Printable

At any time, you are permitted to make printed copies for your and your members' reference use.

SAE AS4309D

SAE AS4309D

FITTING, NIPPLE, FLARED TUBE TO PIPE THREAD, FOR SEAL RING..

$41.00 $81.00

SAE AS4310A

SAE AS4310A

FITTING, TEE, FLARED TUBE, INTERNAL THREAD ON RUN, FOR SEAL RING..

$41.00 $81.00

SAE AS4311A

SAE AS4311A

FITTING, TEE, FLARED TUBE, INTERNAL THREAD ON SIDE, FOR SEAL RING..

$41.00 $81.00

SAE AIR4176A

SAE AIR4176A

Cost Versus Benefits of Engine Monitoring Systems..

$41.00 $81.00