• SAE AMS3660E

SAE AMS3660E

  • Polytetrafluoroethylene (PTFE) Moldings General Purpose Grade, As Sintered (Stabilized: Aug 2011)
  • standard by SAE International, 08/25/2011
  • Category: SAE

$81.00 $41.00

This specification covers virgin, unfilled, polytetrafluoroethylene (PTFE) in the form of molded rods, tubes, and shapes. This specification does not apply to product over 12 inches (305 mm) in dimension parallel to the direction of applied molding pressure, rods under 0.750 inch (19.05 mm) in diameter, and tubes having wall thickness under 0.500 inch (12.70 mm).

These moldings have been used typically for parts such as, bushings and insulators, requiring chemical inertness and good mechanical and electrical properties up to 500 \mDC (260 \mDF), but usage is not limited to such applications. For applications such as bearins, seals, and back-up rings that do not require dielectric properties it is recommended to use AMS 3678/1 Grade A.
PDF

All of our standards document are available in PDF (Portable Document Format), an electronic, downloadable format.You will be able to download the file in your account downloads.

Multi-User Access

After purchasing, you have the ability to assign each license to a specific user.

Printable

At any time, you are permitted to make printed copies for your and your members' reference use.

SAE AMS4276A

SAE AMS4276A

Aluminum Alloy, Sheet 4.4Cu - 1.5Mg - 0.60Mn (2024-0) Annealed, Fine Grained..

$41.00 $81.00

SAE AMS4277A

SAE AMS4277A

Aluminum Alloy, Sheet 5.6Zn - 2.5Mg - 1.6Cu - 0.23Cr (7075-0) Annealed, Fine Grained..

$41.00 $81.00

SAE AMS4015L

SAE AMS4015L

Aluminum Alloy, Sheet and Plate 2.5Mg - 0.25Cr (5052-0) Annealed..

$41.00 $81.00

SAE AMS4157D

SAE AMS4157D

Aluminum Alloy Extrusions 7.7Zn - 2.4Mg - 1.6Cu - 0.16Cr (7049-T73511) Solution Heat Treated, Stress..

$41.00 $81.00