• SAE AMS3668E

SAE AMS3668E

  • Polytetrafluoroethylene (PTFE) Moldings Premium Grade, As Sintered (Stabilized: Aug 2011)
  • standard by SAE International, 08/25/2011
  • Category: SAE

$81.00 $41.00

This specification covers two types of virgin, unfilled polytetrafluoroethylene (PTFE) in the form of molded rods, tubes, and shapes. This specification does not apply to product over 12 inches (305 mm) in length, rods under 0.750 inch (19.05 mm) in diameter, and tubes having wall thickness under 0.500 inch (12.70 mm).

These moldings have been used typically for parts requiring chemical inertness up to 500 \mDF (206 \mDC), and better mechanical and/or electrical properties than AMS 3660, but usage is not limited to such applications. for applications such as bearings, seals, and back-up rings that do not require dielectric properties it is recommended to use AMS 3678/1 GradeA.
PDF

All of our standards document are available in PDF (Portable Document Format), an electronic, downloadable format.You will be able to download the file in your account downloads.

Multi-User Access

After purchasing, you have the ability to assign each license to a specific user.

Printable

At any time, you are permitted to make printed copies for your and your members' reference use.

SAE ARP4277A

SAE ARP4277A

Placard and Marking Standards for Operation of Inflatable Slides and Slide/Rafts..

$41.00 $81.00

SAE J1453_200901

SAE J1453_200901

Fitting¿¿¿O-Ring Face Seal..

$41.00 $81.00

SAE J1318_200901

SAE J1318_200901

Gaseous Discharge Warning Lamp for Authorized Emergency, Maintenance, and Service Vehicles..

$41.00 $81.00

SAE AIR5575

SAE AIR5575

Hot Stamp Wire Marking Concerns for Aerospace Vehicle Applications..

$41.00 $81.00