SAE AMS6330G
- Steel Bars, Forgings, and Tubing 0.65Cr 1.25Ni (0.33-0.38C)
- standard by SAE International, 10/01/2007
- Category: SAE
$81.00
$41.00
This specification covers an aircraft-quality, low-alloy steel in the form of bars, forgings, mechanical tubing, and forging stock.
These products have been used typically for parts 0.750 inch (19.05 mm) and under in nominal section thickness at time of heat treatment requiring a through-hardening steel capable of developing minimum tensile strength of 180 ksi (1241 MPa) at the section center when properly hardened and tempered and for parts of greater section thickness but requiring proportionately lower strength, but usage is not limited to such applications.
These products have been used typically for parts 0.750 inch (19.05 mm) and under in nominal section thickness at time of heat treatment requiring a through-hardening steel capable of developing minimum tensile strength of 180 ksi (1241 MPa) at the section center when properly hardened and tempered and for parts of greater section thickness but requiring proportionately lower strength, but usage is not limited to such applications.
PDF
All of our standards document are available in PDF (Portable Document Format), an electronic, downloadable format.You will be able to download the file in your account downloads.
Multi-User Access
After purchasing, you have the ability to assign each license to a specific user.
Printable
At any time, you are permitted to make printed copies for your and your members' reference use.
