• SAE AMS6351J

SAE AMS6351J

  • Steel, Sheet, Strip, and Plate, 0.95Cr - 0.20Mo (0.28 - 0.33C) (SAE 4130), Spheroidized
  • standard by SAE International, 10/05/2011
  • Category: SAE

$81.00 $41.00

This specification covers an aircraft-quality, low-alloy steel in the form of sheet, strip, and plate,

These products have been used typically for general use where deep drawing and forming are required, but usage is not limited to such applications. Product may be through-hardened to a minimum tensile strength of 180 ksi (1241 MPa) in sections 0.125 inch (3.18 mm) and under in nominal thickness and proportionately lower strength in heavier section thicknesses.
PDF

All of our standards document are available in PDF (Portable Document Format), an electronic, downloadable format.You will be able to download the file in your account downloads.

Multi-User Access

After purchasing, you have the ability to assign each license to a specific user.

Printable

At any time, you are permitted to make printed copies for your and your members' reference use.

SAE AS1033F

SAE AS1033F

FITTING, TEE, STANDARD AND REDUCER, BULKHEAD ON RUN, FLARED..

$41.00 $81.00

SAE AS1035F

SAE AS1035F

FITTING, TEE, STANDARD AND REDUCER, FLARED..

$41.00 $81.00

SAE AS1036H

SAE AS1036H

FITTING, CROSS, STANDARD AND REDUCER, FLARED..

$41.00 $81.00

SAE AS15720C

SAE AS15720C

FITTING, LUBRICATION, HYDRAULIC, THROAT OR SURFACE CHECK, .250-28 TAPER THREADS, CORROSION RESISTANT..

$41.00 $81.00