• SAE AMS7004

SAE AMS7004

  • Titanium Alloy Preforms from Plasma Arc Directed Energy Deposition Additive Manufacturing on Substrate Ti-6Al-4V Stress Relieved
  • standard by SAE International, 01/31/2019
  • Category: SAE

$81.00 $41.00

This specification covers preforms fabricated up through 5.5 inches (140 mm) inclusive in deposition width thickness (see 8.2.5) using a Plasma Arc Directed Energy Deposition (PA-DED) additive manufacturing process on a Ti-6Al-4V substrate that are subjected to post-deposition stress relief heat treatment. This is a wire fed additive manufacturing process. If required by the CEO, preforms may require subsequent machining to meet requirements for their intended final part application.
PDF

All of our standards document are available in PDF (Portable Document Format), an electronic, downloadable format.You will be able to download the file in your account downloads.

Multi-User Access

After purchasing, you have the ability to assign each license to a specific user.

Printable

At any time, you are permitted to make printed copies for your and your members' reference use.

SAE J2188_201807

SAE J2188_201807

Commercial Truck and Bus SAE Recommended Procedure for Vehicle Performance Prediction and Charting (..

$41.00 $81.00

SAE AMS4248D

SAE AMS4248D

Aluminum Alloy Hand Forgings and Rolled Rings 1.0Mg - 0.60Si - 0.28Cu - 0.20Cr (6061-T652) Solution ..

$41.00 $81.00

SAE AMS4482A

SAE AMS4482A

Cast Aluminum Alloy Composite 4.6Cu - 3.4Ti - 1.4B - 0.75Ag - 0.27Mg (205.0/TiB2/3p-T7P) Sand Cast, ..

$41.00 $81.00

SAE AMS4907L

SAE AMS4907L

Titanium Alloy, Sheet, Strip, and Plate 6.0Al - 4.0V, Extra Low Interstitial Annealed..

$41.00 $81.00