• SAE AS4775A

SAE AS4775A

  • Aircraft Maintenance Jacks - General Requirements
  • standard by SAE International, 01/14/2011
  • Category: SAE

$81.00 $41.00

This document covers the general requirements for hydraulic aircraft jacks. It can be applied to tripod, unipod, and axle jacks that may be used on open ramp areas as well as in the aircraft hanger.

Throughout this Aerospace Standard, the minimum essential criteria are identified by the key word “shall”. Recommended criteria are identified by use of the key word “should”. Deviation from recommended criteria should only occur after careful consideration and thorough service evaluation have shown alternate methods to provide an equivalent level of safety.

The term “vertical load” throughout this Aerospace Standard is defined as the force imposed on the aircraft jack at the airframe jack point.
PDF

All of our standards document are available in PDF (Portable Document Format), an electronic, downloadable format.You will be able to download the file in your account downloads.

Multi-User Access

After purchasing, you have the ability to assign each license to a specific user.

Printable

At any time, you are permitted to make printed copies for your and your members' reference use.

SAE AS14487A

SAE AS14487A

CLAMP, LOOP, PLASTIC, WIRE SUPPORT, METRIC (Stabilized: Jul 2013)..

$41.00 $81.00

SAE AS151701B

SAE AS151701B

STUD, STEPPED, 1.5 DIA ENGAGEMENT, CADMIUM PLATED, STEEL UNS G87400, .5000-13 UNS X .4375-20 UNF-3A..

$41.00 $81.00

SAE AS154701A

SAE AS154701A

STUD - STEPPED, 2 DIA ENGAGEMENT .2500-20UNS X .1900-32UNF-3A..

$41.00 $81.00

SAE AS3261A

SAE AS3261A

NUT, SELF-LOCKING, CLIP, FLOATING, AS7251 (UNS S66286)..

$41.00 $81.00