• SAE AS4775B

SAE AS4775B

  • Aircraft Maintenance Jacks - General Requirements
  • standard by SAE International, 01/10/2017
  • Category: SAE

$81.00 $41.00

This document covers the general requirements for hydraulic aircraft jacks. It can be applied to tripod, unipod, and axle jacks that may be used on open ramp areas as well as in the aircraft hangar.

Throughout this Aerospace Standard, the minimum essential criteria are identified by the key word "shall". Recommended criteria are identified by use of the key word "should". Deviation from recommended criteria should only occur after careful consideration and thorough service evaluation have shown alternate methods to provide an equivalent level of safety.

The term "vertical load" throughout this Aerospace Standard is defined as the force imposed on the aircraft jack at the airframe jack point.

PDF

All of our standards document are available in PDF (Portable Document Format), an electronic, downloadable format.You will be able to download the file in your account downloads.

Multi-User Access

After purchasing, you have the ability to assign each license to a specific user.

Printable

At any time, you are permitted to make printed copies for your and your members' reference use.

SAE AMS4276B

SAE AMS4276B

Aluminum Alloy, Sheet 4.4Cu - 1.5Mg - 0.60Mn (2024-O) Annealed, Fine Grained..

$41.00 $81.00

SAE AMS4408A

SAE AMS4408A

Aluminum Alloy, Plate (7140-T7651) 6.6Zn - 1.8Cu - 2.0Mg - 0.10Zr Solution Heat Treated, Stress Reli..

$41.00 $81.00

SAE AMS5689G

SAE AMS5689G

Steel, Corrosion and Heat Resistant, Wire 18Cr - 10.5Ni - 0.40Ti (321) Solution Heat Treated..

$41.00 $81.00

SAE AMS5697G

SAE AMS5697G

Steel, Corrosion-Resistant, Wire 19Cr - 9.5Ni (304) Solution Heat Treated..

$41.00 $81.00