• SAE J 429

SAE J 429

  • Mechanical and Material Requirements for Externally Threaded Fasteners
  • standard by SAE International, 04/30/2013
  • Category: SAE

$81.00 $41.00

This SAE Standard covers the mechanical and material requirements for inch-series steel bolts, screws, studs, screws for sems, and U-bolts used in automotive and related industries in sizes to 1 1/2 in inclusive.

The term "stud" as referred to herein applies to a cylindrical rod of moderate length threaded on either one or both ends or throughout its entire length. It does not apply to headed, collared, or similar products which are more closely characterized by requirements shown herein for bolts.

The mechanical properties included in Table 1 were compiled at an ambient temperature of approximately 20 \mDC and (68 \mDF). These properties are valid within a temperature range which depends upon the material grade used and thermal and mechanical processing. Other properties such as fatigue behavior, corrosion resistance, impact properties, etc., are beyond the scope of this document and responsibility for ensuring the acceptability of the product for applications where conditions warrant consideration of these other properties must be borne by the end user.
PDF

All of our standards document are available in PDF (Portable Document Format), an electronic, downloadable format.You will be able to download the file in your account downloads.

Multi-User Access

After purchasing, you have the ability to assign each license to a specific user.

Printable

At any time, you are permitted to make printed copies for your and your members' reference use.

SAE AMS2451/13

SAE AMS2451/13

Plating, Brush, Silver..

$41.00 $81.00

SAE AMS3117

SAE AMS3117

Primer Zinc Molybdate..

$41.00 $81.00

SAE AMS2451/10A

SAE AMS2451/10A

Plating, Brush, Tin-Zinc Low Hydrogen Embrittlement..

$41.00 $81.00

SAE AMS2800D

SAE AMS2800D

Identification Finished Parts..

$41.00 $81.00