• SAE J1113/3_201008

SAE J1113/3_201008

  • Conducted Immunity, 250 kHz to 400 MHz, Direct Injection of Radio Frequency (RF) Power
  • standard by SAE International, 08/05/2010
  • Category: SAE

$81.00 $41.00

This part of SAE J1113 specifies the direct RF power injection test method and procedure for testing electromagnetic immunity of electronic components for passenger cars and commercial vehicles. The electromagnetic disturbances considered in this part of SAE J1113 are limited to continuous, narrowband conducted RF energy.

This test method is applicable to all DUT leads except the RF reference ground. The test provides differential mode excitation to the DUT.

Immunity measurements of complete vehicles are generally only possible by the vehicle manufacturer. The reasons, for example, are high costs of a large absorber-lined chamber, preserving the secrecy of prototypes or the large number of different vehicle models. Therefore, for research, development, and quality control, a laboratory measuring method for components shall be applied by the manufacturer. This method is suitable over the frequency range of 250 kHz to 400 MHz.

This direct RF power injection test is particularly effective when used as part of the engineering development of the electronic component (at the prototype PCB level) where the line by line diagnostic capabilities of this test facilitate cost-effective circuit board level improvments in the RF immunity performance of the module or component.
PDF

All of our standards document are available in PDF (Portable Document Format), an electronic, downloadable format.You will be able to download the file in your account downloads.

Multi-User Access

After purchasing, you have the ability to assign each license to a specific user.

Printable

At any time, you are permitted to make printed copies for your and your members' reference use.

SAE J2819_201905

SAE J2819_201905

TP2.0 Vehicle Diagnostic Protocol..

$41.00 $81.00

SAE ARP1897A

SAE ARP1897A

Clamp Selection and Installation Guide..

$41.00 $81.00

SAE AS1032G

SAE AS1032G

Fitting, Tee, Standard and Reducer, Bulkhead on Run, Internal Port on Run, Flared..

$41.00 $81.00

SAE AS129293B

SAE AS129293B

STUD - STRAIGHT, DRILLED, STEEL (SAE 8740), CADMIUM PLATED, .3750-16UNS X .3750-24UNF-3A..

$41.00 $81.00