• SAE J1730_201203

SAE J1730_201203

  • ABS Exciter Ring Location Standardization
  • standard by SAE International, 03/15/2012
  • Category: SAE

$81.00 $41.00

This SAE Recommended Practice is to establish the Antilock Brake System (ABS) sensor interface and envelope dimensions for standardizing the location of the ABS rings mounted on the inner end of the spoke wheels, hubs and hub-rotor assemblies on the following axle designations: a. FF; b. FL; c. FC; d. FH; e. L; f. R; g. U; h. W; j. N; k. P.

This document provides standardized wheel end ABS sensor interface dimensions for spoke wheels, hubs and hub-rotor assemblies intended for normal highway use on trucks, buses, truck trailers, and multipurpose vehicles. The illustrations given in the document are for reference only. These illustrations show typical sensor ring designs and mountings, but are not limited to those shown. Serviceability considerations are not covered in this document.
PDF

All of our standards document are available in PDF (Portable Document Format), an electronic, downloadable format.You will be able to download the file in your account downloads.

Multi-User Access

After purchasing, you have the ability to assign each license to a specific user.

Printable

At any time, you are permitted to make printed copies for your and your members' reference use.

SAE J1330_200712

SAE J1330_200712

Photometry Laboratory Accuracy Guidelines..

$41.00 $81.00

SAE AS5767

SAE AS5767

Fitting Assembly, Tee, Female Flareless, Axially Swaged, Hydraulic, 5080 psi..

$41.00 $81.00

SAE J524_200712

SAE J524_200712

Seamless Low-Carbon Steel Tubing Annealed for Bending and Flaring..

$41.00 $81.00

SAE J267_200712

SAE J267_200712

Wheels/Rims - Performance Requirements and Test Procedures - Truck and Bus..

$41.00 $81.00