• SAE J1985_201310

SAE J1985_201310

  • Fuel Filter - Initial Single-Pass Efficiency Test Method
  • standard by SAE International, 10/07/2013
  • Category: SAE

$81.00 $41.00

This SAE Standard is intended for all sizes of fuel filters, so a variety of test stands may be required depending upon flow rate. The low contamination level, downstream clean-up filter, and short duration of the test, ensures that the particle retention ability of the filter is measured in a single pass as no appreciable loading or regression will occur.
PDF

All of our standards document are available in PDF (Portable Document Format), an electronic, downloadable format.You will be able to download the file in your account downloads.

Multi-User Access

After purchasing, you have the ability to assign each license to a specific user.

Printable

At any time, you are permitted to make printed copies for your and your members' reference use.

SAE AMS4122L

SAE AMS4122L

Aluminum Alloy Bars, Rods, and Wire Rolled or Cold Finished, and Rings 5.6Zn - 2.5Mg - 1.6Cu - 0.23C..

$41.00 $81.00

SAE AMS4429A

SAE AMS4429A

Magnesium Alloy Castings, Sand 2.8Nd - 1.4Gd - 0.4Zn - 0.6Zr (EV31A - T6) Solution and Precipitation..

$41.00 $81.00

SAE J2979_201205

SAE J2979_201205

Test Method for Vulcanized Rubber and Thermoplastic Elastomer Determination of Compressive Stress Re..

$41.00 $81.00

SAE J619_201205

SAE J619_201205

Flywheels for Two-Plate Spring-Loaded Clutches (Stabilized: May 2012)..

$41.00 $81.00