• SAE J2486_201304

SAE J2486_201304

  • Tension Indicating Washer Tightening Method for Fasteners
  • standard by SAE International, 04/15/2013
  • Category: SAE

$81.00 $41.00

This SAE Recommended Practice covers installation and inspection methods for fasteners which are tensioned using Tension Indicating Washers (TIWs) as a means to ensure that adequate tension is developed in mechanically fastened joints. Figure 1 depicts a typical TIW, and Figure 2 depicts a fastener assembly with a TIW before and after tensioning.

This document describes practices for the use of TIWs which are typically produced for use with SAE J429 Grade 5 and Grade 8 fasteners or their metric counterparts, although the same principals hold true for bolted joints using other fasteners. Users are advised to contact a manufacturer for advice on use of these products before using them with special fasteners or applications.

This document defines and illustrates preferred installation and inspection methodologies. The contents of this document are presented as accurately as possible; however, responsibility for its application lies with the user.
PDF

All of our standards document are available in PDF (Portable Document Format), an electronic, downloadable format.You will be able to download the file in your account downloads.

Multi-User Access

After purchasing, you have the ability to assign each license to a specific user.

Printable

At any time, you are permitted to make printed copies for your and your members' reference use.

SAE AMS6946C

SAE AMS6946C

Titanium Alloy, Sheet, Strip, and Plate 4Al - 2.5V - 1.5Fe Annealed..

$41.00 $81.00

SAE AMS5390G

SAE AMS5390G

Nickel Alloy, Corrosion and Heat-Resistant, Investment Castings 47.5Ni - 22Cr - 1.5Co - 9Mo - 0.60W ..

$41.00 $81.00

SAE AIR1828B

SAE AIR1828B

Guide to Engine Lubrication System Monitoring..

$41.00 $81.00

SAE ARP4260B

SAE ARP4260B

Photometric and Colorimetric Measurement Procedures for Airborne Electronic Flat Panel Displays..

$41.00 $81.00