• SAE J2717_201805

SAE J2717_201805

  • Tests to Define Tire Size (Geometry), Mass, and Inertias
  • standard by SAE International, 05/16/2018
  • Category: SAE

$81.00 $41.00

This SAE Recommended Practice describes a trio of test methods which determine basic tire size (geometry), mass, and moments of inertia. The methods apply to any tire so long as the equipment is properly scaled to conduct the measurements for the intended test tire. The data are suitable for determining parameters for road load models and for comparative evaluations of the measured properties in research and development.

NOTE: Herein, road load models are models for predicting forces applied to the vehicle spindles during operation over irregular surfaces paved or unpaved. Within the context of this Recommended Practice, forces applied to the surface on which the tire is operating are not considered.

PDF

All of our standards document are available in PDF (Portable Document Format), an electronic, downloadable format.You will be able to download the file in your account downloads.

Multi-User Access

After purchasing, you have the ability to assign each license to a specific user.

Printable

At any time, you are permitted to make printed copies for your and your members' reference use.

SAE AS27197A

SAE AS27197A

Seal, Plain, Rubber (Hot Air Resistant 400 °F) Mold in Groove..

$41.00 $81.00

SAE AS27198A

SAE AS27198A

Seal, Plain, Rubber (-65 to +350 °F Fuel Resistant), Mold in Groove..

$41.00 $81.00

SAE AMS2411G

SAE AMS2411G

Plating, Silver, for High Temperature Applications..

$41.00 $81.00

SAE AS27196A

SAE AS27196A

Gasket, Rubber, Fluid Resistant, Oils, Synthetic Oils and Fuels (-65 to +400 °F), Mold in Groove..

$41.00 $81.00