• SAE J89_201811

SAE J89_201811

  • Dynamic Cushioning Performance Criteria for Snowmobile Seats
  • standard by SAE International, 11/14/2018
  • Category: SAE

$81.00 $41.00

This SAE Recommended Practice encompasses the significant factors which determine the effectiveness of a seat system in limiting spinal injury during vertical impacts between the rider and the snowmobile seat system. The document is intended to provide a tool for the development of safer snowmobile seats. It is recognized that the seat is only a portion of the entire vehicle protective suspension system. It is, however, usually required that the seat serve as added protection to the suspension system, since the latter may "bottom out" during a severe impact.

The term "seat" refers to the occupant-supporting system not normally considered part of the vehicle suspension or frame system. In some cases, it may include more than the foam cushion.

This document provides the minimum requirements for performance of a general seat system, and a description of specific means of evaluating the shock-absorbing characteristics of foam seat cushions using a specific testing procedure and a companion seat evaluation chart.

The test input and means of interpreting the results are unique to the seats of typical recreational snowmobiles. Therefore, this document is to be used for snowmobile seats only and is not to be used to evaluate seats of any other type of vehicle. In addition, it should not be applied to seats of snow vehicles of significantly different design, dimensions, construction, or intended usage from the typical recreational snowmobile illustrated in SAE J33.

PDF

All of our standards document are available in PDF (Portable Document Format), an electronic, downloadable format.You will be able to download the file in your account downloads.

Multi-User Access

After purchasing, you have the ability to assign each license to a specific user.

Printable

At any time, you are permitted to make printed copies for your and your members' reference use.

SAE AS4209B

SAE AS4209B

FITTING END ASSEMBLY, INTERNAL THREAD, RETAINED NUT, BEAM SEAL, DESIGN STANDARD..

$41.00 $81.00

SAE AS4212A

SAE AS4212A

FITTING, UNION, REDUCER, BEAM SEAL..

$41.00 $81.00

SAE AS4213A

SAE AS4213A

FITTING, PLUG, BEAM SEAL, HYDRAULIC..

$41.00 $81.00

SAE AS4214A

SAE AS4214A

FITTING, CAP ASSEMBLY, BEAM SEAL, HYDRAULIC..

$41.00 $81.00