• SAE J905_200909

SAE J905_200909

  • Fuel Filter Test Methods
  • standard by SAE International, 09/01/2009
  • Category: SAE

$81.00 $41.00

The purpose of this fuel filter test method is to provide standardized methods for evaluating the performance characteristics of fuel filters by bench test methods. This, combined with data obtained from application tests, may be used to establish standards of performance for filters when tested by these standard methods. Many variations in requirements of filtration to protect fuel supply equipment on engines and variations in operating conditions make it difficult to specify meaningful "in-service" performance standards by which a filter may be judged. By the use of these standard test methods, test conditions are always the same, and comparisons of the laboratory performance of filters may be made with a high degree of confidence. Once the requirements of a particular application are known, performance standards for suitable filters may be established by these test methods, and adequacy of performance of filters for the job may be determined.

In order to achieve the highest degree of reliability of test results, the procedures and equipment must conform to those specified in this code. No minimum performance requirements for filters have been specified, since these are the responsibility of the user and manufacturer. Only the methods of determining, interpreting, and reporting performance characteristics are the proper province of this SAE Standard.

Separate chapters cover the test methods necessary to evaluate the several functional capabilities and mechanical properties of the filter. Each chapter is complete with recommended materials, apparatus, and procedures for testing and evaluation. The chapters are:

  1. Chapter 1—Resistance to Flow (Section 3)

  2. Chapter 2—Filter Capacity and Contaminant Removal Characteristics (Section 4)

  3. Chapter 3—Media Migration Test (Section 5)

  4. Chapter 4—Collapse Test (Section 6)

  5. Chapter 5—Ability to Meet Environmental Conditions (Section 7)

  6. Chapter 6—Installation and Removal (Section 8)

  7. Chapter 7—Mechanical Tests (Section 9)

  8. Chapter 8—Material Compatibility (Section 10)

To simplify the chapters covering test methods, information of importance but not directly involved in test methods is covered in appendices as follows:

  1. Methods for Sample Analysis (Appendix A)

PDF

All of our standards document are available in PDF (Portable Document Format), an electronic, downloadable format.You will be able to download the file in your account downloads.

Multi-User Access

After purchasing, you have the ability to assign each license to a specific user.

Printable

At any time, you are permitted to make printed copies for your and your members' reference use.

SAE AS9895A

SAE AS9895A

BOLT, MACHINE - DOUBLE HEXAGON EXTENDED WASHER HEAD, DRILLED, AMS 5616, .2500-28 UNJF-3A..

$41.00 $81.00

SAE J1406_200710

SAE J1406_200710

Application of Hydraulic Brake Hose to Motor Vehicles--Wheel End and Axle..

$41.00 $81.00

SAE AMS5640U

SAE AMS5640U

Steel, Corrosion-Resistant, Bars, Wire, and Forgings, 18Cr - 9.0Ni, Free Machining..

$41.00 $81.00

SAE USCAR35

SAE USCAR35

TEST PROCEDURES FOR EVALUATING BOLT-LOAD RETENTION OF MAGNESIUM ALLOYS..

$41.00 $81.00